X-sectioning in wildfire 2.0

Hi,
since i am in position to create some cross sections in
different level in each quarter of the part in a single view.It
means,if you have seen a cylindrical part on its top view,you are
needed to see different cross section in each quarter (i.e all cross
sections should not be same).

plz guide me to acheive this...

Thanks in advance.

Regards,
sathish

 

Check the Help files, under Sections, for Offset section (section creation
in the model), Full align and Full unfold (section display in the drawing).
I suspect that what you are trying to display can be accomplished with one
of these.

David Janes