When creating drawing dims only, model baselines may not be used

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by sbarrett, Jan 6, 2006.

  1. sbarrett

    sbarrett Guest

    I create (and also modify) a lot of drawings for sheetmetal parts and
    usually use ordinate dimensions to dimension the flat pattern. I often
    get the following error when working on other peoples drawings: "When
    creating drawing dims only, model baselines may not be used". Is there
    any way to add a dimension to this baseline? So far the only work
    around I have is to create a new dimension and turn it into an ordinate
    one and then place the 0.00 on top of the previously existing one.
     
    sbarrett, Jan 6, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Commands May not be nested more than 4 deep error.

  2. Pin names not used when extracting layout --> spice netlist

  3. May I run spectre simulation with hspice model?

  4. A. G. Lisi's E8 model may be showing us what both our space & timereally are.

  5. No model tree when opening a drawing only...

  6. Is it only me.....or does display only surface not work in shaded section views.

  7. acadiso not showing correctly when used in an imperial drawing

  8. ERROR ... commands may not be nested more than 4 deep

Loading...