What Ver of ACAD, did VBA become available.

Discussion in 'AutoCAD' started by GTASteve, Nov 17, 2004.

  1. GTASteve

    GTASteve Guest

    Sounds like a silly question, but I can't remember.

    I have an associate, that uses R14, that wants to take advantage of some simple VBA Macros I wrote...

    I thought sure, then I thought, wait, did R14 have VBA?...

    Does anyone remember what release it became available?

    Cheers,

    Steve
     
    GTASteve, Nov 17, 2004
    #1
    1. Advertisements

  2. GTASteve

    kemp Guest

    I believe you are in luck. As far as I can recall r14 is the release VBA
    became available.

    kemp
     
    kemp, Nov 17, 2004
    #2
    1. Advertisements

  3. GTASteve

    GTASteve Guest

    Awesome, thanks...

    One less problem on today's plate. ;-)

    Ta.
     
    GTASteve, Nov 17, 2004
    #3
  4. GTASteve

    CJ Follmer Guest

    it doesn't work for us. we have 14 and i've been unable to make vba work.
    It will load the editor and such but when you actually run the macro it does
    nothing. Then when you exit autocad it gives an error message. Could be
    our install of 14 though. I tried it on two different pc's and it bombed
    the same way both times.

    cj
     
    CJ Follmer, Nov 17, 2004
    #4
  5. GTASteve

    David Kozina Guest

    IIRC, VBA for R14 came with a Service Pack update a few months after the
    original release.
    Perhaps your reseller would be able to provide you with a copy if you don't
    have it.

    Best regards,
    David Kozina
     
    David Kozina, Nov 17, 2004
    #5
  6. GTASteve

    Murph Guest

    I want to say it was the second release of R14 (R14.1 ?) That had VBA, maybe
    I'm thing of Vlisp. Anyways CJ if IRC the VBA in R14 will error out because
    of MS overwriting some common dll files. If it was installed and MS office
    was installed afterwards or an update to MS software. Even a SP installed
    afterwards would give you errors when running VBA in ACAD.

    Murph
     
    Murph, Nov 17, 2004
    #6
  7. GTASteve

    Murph Guest

    That's what I'm talking about R14.1 but you beat me to it.

    Murph
     
    Murph, Nov 17, 2004
    #7
  8. GTASteve

    Anne Brown Guest

    Anne Brown, Nov 17, 2004
    #8
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.