What does this error mean?

Status
Not open for further replies.

Careyr

Usenet Archive
Joined
Dec 20, 2001
Messages
9
Reaction score
0
"Feature aborted because section entities overlap."

I went through the sketch, and erased all of the lines looking for overlap. I couldn't find any overlapping parts. Pro lets me get out of the sketch mode, which normally does not happen if I have overlapping lines. I get the error when I try to give the part depth, either blind or up to surface. I am allowed to enter a value for the blind depth. I get the error after I hit the "ok" command.

The part is an aluminum extrusion that has a lot of complex geometry. Because of this, I have broken it into two sections. The first had no problems. The only constraints that I am using are equal radii, parallel, and collinear.

Maybe this is Pro's way of telling me to upgrade to 2000i squared.

Thanks. I appreciate the help.

Carey
 
Sounds like the complex cross section is leading to problems.

One easy way at dealing with complex cross sections is to sketch a few datum curves which define the section. Then, in order to create the feature just do a use edge a pick "chain". Pick start and end curves of each curve created above. it should work...

MJS

"Careyr" wrote:

"Feature aborted because section entities overlap."

I went through the sketch, and erased all of the lines looking for overlap. I couldn't find any overlapping parts. Pro lets me get out of the sketch mode, which normally does not happen if I have overlapping lines. I get the error when I try to give the part depth, either blind or up to surface. I am allowed to enter a value for the blind depth. I get the error after I hit the "ok" command.

The part is an aluminum extrusion that has a lot of complex geometry. Because of this, I have broken it into two sections. The first had no problems. The only constraints that I am using are equal radii, ...
 
"MJS" wrote:
Sounds like the complex cross section is leading to problems.

One easy way at dealing with complex cross sections is to sketch a few datum curves which define the section. Then, in order to create the feature just do a use edge a pick "chain". Pick start and end curves of each curve created above. it should work...

MJS

"Careyr" wrote:

> "Feature aborted because section entities overlap."
...
There is another possibility. It is possible that this error occurs if a feature, like a cut or protrusion, intersects with another cut or protrusion on a very small point or line. Try to make a protrusion that overlaps the other protrusion a little bit more. It is not a nice way to handle the problem, but it can work!
 
I've bumped into this when I shelled out a part and added a protrusion that invaded the space of the surface that I used as a reference for the shell.

Just my 2 cents worth.

White Horse

J. Willems wrote:

"MJS" wrote:

>Sounds like the complex cross section is leading to problems.
>
>One easy way at dealing with complex cross sections is to sketch a few datum
>curves which define the section.
>Then, in order to create the feature just do a use edge a pick "chain".
>Pick start and end curves of each curve created above. it should work...
>
>MJS
>
>"Careyr" wrote:
...
 
Status
Not open for further replies.

Latest threads

Back
Top