vxl generate hiearchy

Discussion in 'Cadence' started by vtcad, May 14, 2010.

  1. vtcad

    vtcad Guest

    When doing a GEN FROM SOURCE, is it possible to force VXL to generate
    all hierarchical blocks in my schematic(rather than flat devices)? I
    know this is possible to do if I generate all the lower blocks first,
    then generate the top level.
     
    vtcad, May 14, 2010
    #1
  2. vtcad

    Andrew Beckett Guest

    vtcad wrote, on 05/14/10 19:47:
    In IC61X you can use the Configure Physical Hierarchy tool to allow you to be
    able to create "soft blocks" for specified hierarchical blocks - and then do
    things like pin optimization (either manual alignment or automated), and finally
    when you decend into it you can do gen-from source and so on to place the
    components in that level.

    Some of this can also be done with the Preview floorplanning in IC5141.

    Regards,

    Andrew.
     
    Andrew Beckett, May 28, 2010
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. VXL-placer form -- how to auto-populate the field: rules?

  2. VXL - show incomplete nets - leaves a traceback!

  3. VXL and CDS_Netlisting_Mode

  4. VXL Bindkey cheatsheets?

  5. Matching components and nets with VXL

  6. VXL-SKILL : How to find the schematic window from the layout window

  7. VXL change layer for adding paths and rectangles

Loading...