voltage storm filtering presistors

Discussion in 'Cadence' started by Rick Mattern, May 24, 2011.

  1. Rick Mattern

    Rick Mattern Guest

    When running voltagStorm, I get the following warning. The nets are
    power but not global. The presistors that
    are filtered all have both the MINUS and PLUS tied to vdd_h

    .....any ideas?


    \o STARTING TO FILL IN THE RESULTS FORM ...
    \o
    \o WARNING [VSA_MSG_105]: Parasitic resistors with no simulation data.
    The simulation did not save node voltage information for some
    parasitic resistors.
    \o This can happen when the pin on the extracted cell uses the "!"
    character to designate a global net.
    \o The following parasitic resistor instances will not be included
    in the analysis results.
    \o rj_1_1091 , rg1293 , rd2200 , rd1767 , rd1546 , rh915 , rf1227 ,
    rl1936 , rl605 , rh1106 ,
    \o rl1640 , rj451 , rd3030 , rh4979 , rd2616 , rp1175 , rl1534 ,
    rh4537 , rh4524 , rh4473 , rd3616 ,
    \o rj188 , rp697 , rd3568 , rh4314 , rj932 , rg1215 , rj_1_1124 ,
    rp833 , rh4480 , rd3741 , rh6685 ,
     
    Rick Mattern, May 24, 2011
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Architecture for Low voltage, High Speed, Switched-Capacitor Sigma-Delta modulator.

  2. Threshold voltage equation in Spectre simulator

  3. Is it possible to plot the fundamental frequency vs. tuning voltage in swept pss analysis?

  4. voltage values for multiple instance voltage sources

  5. How do I measure voltage at trigger signal with MDL?

  6. why can't I sweep the threshold voltage using OCEAN?

  7. O.T. Horrific storm damage

  8. storm water system with steep slopes

Loading...