V8 and .dwg instability.......?

Status
Not open for further replies.

Gavern

Usenet Archive
Joined
Dec 2, 2001
Messages
1
Reaction score
0
Guys,

Just started a project based on Acad..

Up until now we've been going through the translation to uStation and then re-translation back to Acad after the work has been done.... pretty tedious actually getting everything to look and be spot on to client standards.

For the new project, it was decided to go V8 for it's .dwg interchangeability... rather impressed at first.

However, one problem that keeps arising is that on occasion when switching between .dwgs (client has one file for details, a second for dimensions and a third as paperspace where the first two are xref'd in) is that on the odd occasion the changes aren't saved to the .dwg file... even though the preview on reopening does show the changes.....

As a trial, one simple line was drawn across the daiwng and then saved. When reopened, the preview shows the change, but on opening the drawing is back to original.... go figure..??

Any ideas?

Cheers,
Gavern
 
"Gavern" wrote:

Guys,

Just started a project based on Acad..

Up until now we've been going through the translation to uStation and then re-translation back to Acad after the work has been done.... pretty tedious actually getting everything to look and be spot on to client standards.

For the new project, it was decided to go V8 for it's .dwg interchangeability... rather impressed at first.

However, one problem that keeps arising is that on occasion when switching ...

Hi Gavern,

Have you check the display depth of your drawings.....? Autocad and Microstation got different display depth or z please check. If it is not the display depth check on the units or scale. Hope this help a bit.

Interchanging DWG to DGN or DGN to DWG....is not always perfect as it should be. Proper setting of conversion is needed to attain perfectly.

Cheers,

Mel Arquiza
Home Page Design
http://hpd.welcome.to
 
Status
Not open for further replies.

Latest threads

Back
Top