swept blend

Status
Not open for further replies.

SCOT GREER

Usenet Archive
Joined
Dec 2, 2001
Messages
56
Reaction score
0
Hi I am trying to add another cross section in the middle between the two ends which will be different from the ends, How do I add points at which I can sketch a new cross section

Thanks Scot
 
You have to go in the ISNSERT MODe, before the swept feature, ADD DATUM POINT on the curve you use as trajectory. than DELETE the insert mode, and redefine the swept....
should works...

bye

"SCOT GREER" ha scritto nel messaggio

Hi I am trying to add another cross section in the middle between the two ends which will be different from the ends, How do I add points at which I can sketch a new cross section

Thanks Scot
 
I don't know which version you're using, but in older releases, it was impossible to add additional sections to a swept blend after it was created. In 2001 (possibly 2000i2 also, but I don't remember), you can redefine the sweep and select to edit the sections. You will have a menu to add sections.

-Jon

"-= Sasha =-" wrote:

You have to go in the ISNSERT MODe, before the swept feature, ADD DATUM POINT on the curve you use as trajectory. than DELETE the insert mode, and redefine the swept....
should works...

bye

"SCOT GREER" ha scritto nel messaggio

> Hi I am trying to add another cross section in the middle between the
two
> ends which will be different from the ends, How do I add points at which
I
> can sketch a new cross section
>
> Thanks Scot
>
>
 
Status
Not open for further replies.

Latest threads

Back
Top