Stretching a line

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by 1-2-3, Nov 7, 2006.

  1. 1-2-3

    1-2-3 Guest

    Hello,

    When stretching a line in the drafting mode, how can I keep it to stay
    in the X or Y direction and not to "rubber band"?

    When drawing the line I don't have problems, I right click the desired
    angle and it stays there. But not when stretching it.

    Thank you.
     
    1-2-3, Nov 7, 2006
    #1
  2. 1-2-3

    John Wade Guest

    Draw another line where you want to stretch it to, and trim to that.
     
    John Wade, Nov 7, 2006
    #2
  3. 1-2-3

    David Janes Guest

    I thought I read somewhere that there was an orthogonal mode that could be
    toggled that would keep a line horizontal or vertical when an end point was
    dragged. Can't confirm at the moment but I'd look for that.

    David Janes
     
    David Janes, Nov 7, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. stretching a solid -- & I'm totally lost!

  2. [X-post] Stretching obiects along an angle not along a line.

  3. Stretching Rectangles

  4. Stretching dimensions in 2006

  5. Reestricting stretching

  6. 2005 LT Stretching Plot

  7. Stretching objiects along an angle not along a line.

Loading...