.stl to .igs with SW

Discussion in 'SolidWorks' started by Themis Toumanidou, Feb 24, 2010.

  1. Hello there.
    I'm not familiar to SW however I have 2 .stl files from Avizo and I
    want to convert them to .igs using SW. The .stl 's are two 3D tibia
    figures without mesh and all I want is to convert them to SOLID and
    then insert them to Abaqus for FEM etc etc. Can anybody give me any
    instructions on doing this?

    Thanks in advance.
    Thenia
     
    Themis Toumanidou, Feb 24, 2010
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.