Anne Brown
Usenet Archive
- Joined
- Jul 2, 2003
- Messages
- 323
- Reaction score
- 0
Repost to give the message a subject line
--
Anne Brown
Manager, Moderator
Autodesk Product Support Discussion Groups
Discussion Q&A: http://www.autodesk.com/discussion
-----
Subject:
Wed, 20 Aug 2003 02:24:15 -0700
"Chris Boyd"
autodesk.autocad.customization
If I use the following to determine the start point of a pline (thanks to cj fullmer for help with this..) Is there anyway of using the same user selected points to set the endpoint of the pline as being 50mm from the second point selected without asking to select an endpoint again? (Does this make any sense...?)
(setq pt1 (C:cal "pld(mid,mid,50)"))(command ".pline" pt1);
Chris Boyd
Cameron Taylor Bedford
www.camerontaylor.co.uk
--
Anne Brown
Manager, Moderator
Autodesk Product Support Discussion Groups
Discussion Q&A: http://www.autodesk.com/discussion
-----
Subject:
Wed, 20 Aug 2003 02:24:15 -0700
"Chris Boyd"
autodesk.autocad.customization
If I use the following to determine the start point of a pline (thanks to cj fullmer for help with this..) Is there anyway of using the same user selected points to set the endpoint of the pline as being 50mm from the second point selected without asking to select an endpoint again? (Does this make any sense...?)
(setq pt1 (C:cal "pld(mid,mid,50)"))(command ".pline" pt1);
Chris Boyd
Cameron Taylor Bedford
www.camerontaylor.co.uk
