simulation is still running but the ade-xl believes it has finished

Discussion in 'Cadence' started by Rick Mattern, Aug 15, 2011.

  1. Rick Mattern

    Rick Mattern Guest

    ADE-XL reports corner “pwr” has completed, and has tried to analyze
    the results of it. But when you right click on that corner and
    “output Log” the transcript shows simulation still running. If you
    wait a while and re-click on “output log” then the simulation time has
    increased – so the simulation is still running.

    Has anyone else seen this issue?
     
    Rick Mattern, Aug 15, 2011
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Apploaded, but still unknown command

  2. Is the corner simulation still running?

  3. advance simulation time without running simulation and then re running

  4. How to monitor all ipcBeginProcess (ChidlId) has finished.

  5. how to avoid trying starting ADE L, but directly ADE GXL

  6. (InfoSnap V8) -- Release Candidate 1 -- the major overhaul finished

  7. SW to MasterCam to finished Product - How

  8. Upgraded to 2005 but still want to run 2004 for a while.

Loading...