Set Plot Preview parameters

Discussion in 'AutoCAD' started by petervose, Dec 7, 2004.

  1. petervose

    petervose Guest

    I have witten a simplified (in my opinion anyway) plotting routine, but would like to add a 'Plot Preview' button to my dialog. It appears that Plot Preview takes all the values it needs to produce a preview from the native AutoCAD Plot data, but I was wondering if it were possible to update these values 'behind the scenes' so that the preview takes on my values, and am hoping that someone could tell me how to access them or where they are? Thanks
    Peter
     
    petervose, Dec 7, 2004
    #1

    1. Advertisements

  2. petervose

    OLD-CADaver Guest

    It is my understanding that PLOT PREVIEW uses the current PAGE SETUP or "Previous Plot" settings. Save the page setup and preview from there.
     
    OLD-CADaver, Dec 7, 2004
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to set process/mismatch parameters in Ocean?

  2. set the parameters of the fourier component from analogLib

  3. Plot preview shows extra lines not in drawing

  4. create plot and preview

  5. Exit Plot Preview

  6. Fatal Error in plot preview when panning or zooming

  7. Autocad 2002 full plot preview different than plot

Loading...