Routing w/ interference detection?

Discussion in 'SolidWorks' started by lipkink, Jul 5, 2007.

  1. lipkink

    lipkink Guest

    I am pretty sure the answer to my question is "no", but I'll ask
    because it would be useful if I was wrong.

    When using autoroute in SW routing, is it possible to get the wires to
    recognize that there are other wires and no run into each other? I am
    trying to route several wires through some holes and it would be nice
    if SW could figure out a way to route them without running into each
    other, especially near wire clips. If no, any easy alternatives?

    Thanks
     
    lipkink, Jul 5, 2007
    #1
  2. Within the last 6 weeks or so, someone on this Forum had offered a
    pretty extensive video tutorial on routing. You may want to do a
    search for that here somehow. Or maybe someone will remember who it
    was. If my memory serves me, it was in the neighborhood of 40 MGB in
    size, and also I remember someone stating that it was very high
    quality.
    Jennifer Axiotis
     
    jenniferaxiotis, Jul 5, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.