Route Line (Explode lines) Missing

Discussion in 'SolidWorks' started by Scott Donnelly, Dec 17, 2003.

  1. Scott Donnelly

    Scott Donnelly Guest

    I have an assembly that I have exploded. When I try to added a route
    line to some parts, the route line disappears ~(its not visible) from
    the assembly, but it does show up in the the drawing??!
     
    Scott Donnelly, Dec 17, 2003
    #1
  2. Scott Donnelly

    Steve Tietz Guest

    Make sure you have sketched checked under the view pull down & also make
    sure you are not in large assembly. If you need to be in large assembly
    mode -- then go into the tools options & make sure that the setting for
    sketches to be visible is enabled in large assembly mode.

    Hope this helps.
    Steve Tietz
     
    Steve Tietz, Dec 17, 2003
    #2
  3. Scott Donnelly

    Scott Donnelly Guest

    Thanks Steve, that worked :)

     
    Scott Donnelly, Dec 18, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. draw line to middle of 2 picked lines then offset that line help...

  2. Can SRoute route to the line shape pin of Vdd and GND?

  3. Virtuoso: missing solder...not missing

  4. Explode Sketch Lines

  5. SW2008 BOM - Missing Items - missing?

  6. Route line question

  7. Make single line from parallel lines w/o deleting lines

Loading...