Rounding in Note

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by Aggrevated, Feb 18, 2008.

  1. Aggrevated

    Aggrevated Guest

    Ok. So i have two parameters:

    &Over_Shaft = .4649
    &Over_Shaft_Tol = .0005

    I'm inserting a note into my part by doing a "insert annotation
    feature"->"add"->"note" and type something like:

    <diam-symbol>&Over_Shaft <plusminus-symbol>&Over_Shaft_Tol

    but. What appears on my screen is:

    <diam>.465 <+->.001

    How do I force Pro/e to use 4 place in a note?

    Thanks!
     
    Aggrevated, Feb 18, 2008
    #1
  2. Aggrevated

    mdR Guest

    ~should~ be &over_shaft[.4]
    config settings leading and trailing zeros may have an effect on this
    though.
    ::mark
     
    mdR, Feb 18, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.