Rev Anchor on existing drawings

[T Bennett]

I just loaded Outlook on this new computer, and it is only showing posts from the 8th on, so I don't know if this has been covered.

How do I get the Rev Table anchor on an existing drawing?

Todd Bennett
Mechanical Designer

CELERITY GROUP, INC

 

[T Bennett]

I figured out a work around to add anchors (assuming there isn't a proper way).

To old templates:
1) Open a blank drawing using your template.
2) Add a sheet using the same template.
3) Delete the first sheet.

To existing drawings:
1) Open an existing drawing.
2) Add sheets using the same templates as the relative sheet.
3) Copy the views to the new sheet.
4) Replace your BOM, Rev Block, etc.

Todd Bennett
Mechanical Designer

CELERITY GROUP, INC