Remove black border from inserted clip art

Discussion in 'AutoCAD' started by bbelly, Jan 17, 2008.

  1. bbelly

    bbelly Guest

    Just as the subject says, I have a piece of circular clip art (.jpg)
    that inserts with a square black border. I'd really like to get rid of
    that border.

    If it makes any difference, I can change the original art to most any
    format.

    Thanks
     
    bbelly, Jan 17, 2008
    #1
    1. Advertisements

  2. bbelly

    strawberry Guest

    imageframe 0 (from memory)
     
    strawberry, Jan 17, 2008
    #2
    1. Advertisements

  3. bbelly

    bbelly Guest

    Thanks for the help. I don't know where to get at these settings ...
    don't think I've played with that stuff AT ALL since r 10 or 11 ...
    cobwebs in the synapses since then ;-)

    By the way ... Acad'08

    thanks again
     
    bbelly, Jan 18, 2008
    #3
  4. bbelly

    strawberry Guest

    just type "imageframe" into the command line and then press return/
    spacebar. Then type "0" or "OFF" and press return/spacebar. I have a
    feeling that in Acad08 it's "0" and in earlier releases it's "OFF" but
    I'm not sure.
     
    strawberry, Jan 18, 2008
    #4
  5. bbelly

    bbelly Guest

    RIGHT ON THE MONEY !!!

    THANK YOU
     
    bbelly, Jan 18, 2008
    #5
  6. bbelly

    dannyhaws Guest

    If you still want to see the border but not have it plot than you can use the imageframe command and set the value to 2. Same goes for the PDF frame command. Wait... I just realized that this was posted almost four years ago.... My bad.
     
    dannyhaws, Oct 5, 2011
    #6
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.