Registers can not drive analog ports directly

Discussion in 'Cadence' started by Erik Wanta, Mar 1, 2004.

  1. Erik Wanta

    Erik Wanta Guest

    We are getting the following elaboration error with AMS Designer.

    ncelab: *E,CUVRNA Registers can not drive analog ports directly.

    Has anyone else seen this or have any ideas?
     
    Erik Wanta, Mar 1, 2004
    #1
  2. Erik Wanta

    Andrew Beckett Guest

    Erik,

    The only references to this that I could find were back in AMS20 - and were
    fixed in the s005 subversion of AMS20. I'd be surprised if you are using AMS20
    though?

    Have you tried turning on (or off?) detailed discipline resolution to see if
    that makes a difference.

    Otherwise, you should contact customer support in the usual way.

    Andrew.
     
    Andrew Beckett, Mar 2, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Analog power / Analog clean power?

  2. Can I find out the output resistance (rds or gds) of MOSFET directly from Spectre simulation (w/o us

  3. cadence mixed signal, init registers?

  4. Can I update directly from a base release to USR3 release?

  5. Calibre question: why initial ports before transformation differ from netlist IO subckt ports

  6. can catia v5 save directly to native swx 09 - not as a neutral format

  7. Install 2002 to D drive instead of C drive ?

Loading...