Radial pattern of rectangles - creation using ProWidfire 2.0

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by News, Dec 23, 2004.

  1. News

    News Guest

    To any expert...
    When a hole extrusion is placed on a surface, it is easy to create a radial
    pattern because references become polar.
    When a rectangular extrusion is placed on a surface it gets cartesian
    coords, and patterns are assumed to be of a square array type.
    How can a radial pattern of rectangles be produced?
    Thanks
    from Peter Watt
     
    News, Dec 23, 2004
    #1
  2. News

    Chinh Pham Guest

    Datum on the fly should do fine. (Through axis, Angle)
    Just make sure all dimensions and contrains are referenced to "on the
    fly Datum" and Axis for radial pattern.

    C.Pham
     
    Chinh Pham, Dec 23, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.