QUESTION ABOUT SOLPROF COMMAND

Status
Not open for further replies.

Davide Spreafico

Usenet Archive
Joined
Sep 20, 2001
Messages
3
Reaction score
0
IS POSSIBLE TO CREATE A 2D PROFILE (WITH HIDE LINES BLOCK) OF 3D SOLIDS IN PROSPECTIVE VIEW USING THE SOLPROF COMMAND?
THANK YOU?
 
On Mon, 03 Dec 2001 20:50:54 GMT, "Davide Spreafico"
wrote:

IS POSSIBLE TO CREATE A 2D PROFILE (WITH HIDE LINES BLOCK) OF 3D SOLIDS IN PROSPECTIVE VIEW USING THE SOLPROF COMMAND?

Yes, but you have to be in paperspace in an active viewport to accomplish that end. And you must not post messages in upper case.
(grin)

If you're familiar with paperspace, ignore the following.

If not, read on.

Toggle to paperspace, create a viewport and toggle to modelspace, tilemode=0. That is, you're cursor will be active inside the new floating viewport. Your solids model should be displayed within the viewport. If not, do a zoom extents to find out where it is. Then using dview or whatever model navigation tools you're used to, set the view of the model as you wish it to be displayed.

Issue the SOLPROF command and respond to the various prompts. The defaults will ordinarily give you adequate results.

The SOLPROF command creates two new layers, PVnnn and PHnnn where nnn=the viewport entity handle. The contain, respectively, the visible lines of the model and the hidden lines of the model. You can change the color and linetype of the hidden lines layer to a color that plots lighter (finer pen weight) and dashed to represent hidden lines.

I trust this is what you're asking about???
 
Status
Not open for further replies.

Latest threads

Back
Top