PW2 - how to scale scene designs

Discussion in 'SolidWorks' started by bill allemann, Nov 26, 2003.

  1. I haven't used Photoworks much. I can't find a way to scale down
    the size of bricks, etc that show up in the standard scene "showrooms" for
    walls and floors. Everything looks about 10X normal size compared to my
    models. Any ideas?
    bill allemann, Nov 26, 2003
  2. bill allemann

    Krister L Guest

    In the PW scene editor / room / visbility and materials.... click on the
    button to the right of chosen part.....for example ceiling or floor....this
    will bring up the material editor and under the texture tab You can set the
    "scale" by changing map size

    Krister L
    Krister L, Nov 26, 2003
  3. Bill,

    Under the room tab in the scene manager click on the button located
    next to one of the wall descriptions. When the material editor pops
    up go to the texture tab. You can size the material from there. You
    can also change materials and adjust their properties (for the walls,
    floor or ceiling) while in the material editor.
    Rob Rodriguez, Nov 26, 2003
  4. That did the trick.

    Helpfile semantic misdirections did me in again :)
    bill allemann, Nov 26, 2003
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.