ProMECH Thermal HELP: Trans. prob. with Time Varying Film Coef. and Bulk Temp.

Hi,

Any one have experiences running a Transient problem, with Time
Varying Film Coef. and Bulk Temp.? I got an out put from the CFD
package from the customer, that basically listed Film Coefficient as a
function of time, and the Bulk Temp as a function of time. This dada
is just measured from a single node from the CFD solution, and I need
to apply it to a surface in my model.

I heard this is not possible in ProE2001, but do-able in WildFire, but
I am lost. I went into Convection Condition box, choose Spatial
Variation as Uniform, and Temporal Variation as Time Dependent, and
did the function as Table, but found only 2 columns of data I can
entered in. One for Time, one for Film Coef. I assume.?

Do I need to go the (External Conv. Coef. & Bulk Temp).fnf file route?

How do I map my 3 columns of data(Time--Film Coef--Bulk Temp) in to a
..fnf file?

How do I properly format this file manually? and maps it to every
nodes properly? with AutoGEM? There seems to be a problem to review h
and Tb if Mapping is off(SPR 1068318)
http://www.ptc.com/cs/tan/124224.htm, which made it hard to know if
you did the right thing.