I have read that Pro/Desktop can be run with Pro/Engineer.
Basically the issue is this.
Currently have 2-seats of Pro/E for geometry intensive products. Anticipate rapid increase in other CAD applications where cost of Pro/E is prohibitive and is frankly, like using a sledgehammer to crack a nut.
It is obvious there would be a limit on the compatibility of Pro/D and Pro/E. Does anyone have experience of this kind of dual application where a relatively inexpensive general application software like Pro/D can be coupled to Pro/E to give the advantages of both systems over all products.
In short, how do I get the best of both worlds.....low cost, easy to use package and 'heavy duty' package.
Cheers....Glen
Basically the issue is this.
Currently have 2-seats of Pro/E for geometry intensive products. Anticipate rapid increase in other CAD applications where cost of Pro/E is prohibitive and is frankly, like using a sledgehammer to crack a nut.
It is obvious there would be a limit on the compatibility of Pro/D and Pro/E. Does anyone have experience of this kind of dual application where a relatively inexpensive general application software like Pro/D can be coupled to Pro/E to give the advantages of both systems over all products.
In short, how do I get the best of both worlds.....low cost, easy to use package and 'heavy duty' package.
Cheers....Glen