Polyline and hidden segment question

Discussion in 'AutoSketch' started by Mike C., Dec 29, 2004.

  1. Mike C.

    Mike C. Guest

    When I first draw a polyline, the grab points are on the outside of each
    full length segment. However when a symbol is inserted (a window for
    example), it creates a hidden segment and the grab points are now center
    based to the width of the polyline. The center based grab points aren't
    necesarily aligned with my grid snap. This makes it difficult to move a
    wall, for example, to a new location based on snap points. What's the trick
    for doing this?

    Thanks,

    Mike C.
     
    Mike C., Dec 29, 2004
    #1
  2. Mike C.

    Mike C. Guest

    I figured out that I can click the segment that needs adjusting, hit the 'R'
    key, then enter the x or y coordinates that I want to "bump" my wall out to.
     
    Mike C., Dec 30, 2004
    #2
  3. Mike C.

    ott Guest

    ...or type h (horizontal), v (vertikal)..and all the others. W (working
    point) is very useful in this coherence.
     
    ott, Dec 30, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.