Plotting offset problem

Status
Not open for further replies.

Tom Orner

Usenet Archive
Joined
Dec 31, 2001
Messages
8
Reaction score
0
I can't get an 11x17 plot to come out centered on our HP5000n laser jet printer. It will only shift so far in the x direction no matter what I use for an offset value. I use a modified version of hpgl2.plt.
Any suggestions.
 
"Tom Orner" wrote:

I can't get an 11x17 plot to come out centered on our HP5000n laser jet printer. It will only shift so far in the x direction no matter what I use for an offset value. I use a modified version of hpgl2.plt.
Any suggestions.

Check plotter settings, set to software
 
have a look at your manual and see EXACTLY what your plot area is - it will not be 11x17

On your sheet file, place two diagonal marks indicating a square EXACTLY the size of this plot area - I could tell you in metric, but I do not understrand imperial and use these for indicating your plot fence

Now edit your plt file and have the exact size for your sheet set at the same size as your print area (smaller than 11x17)

Fence area A = Plot Area B and you get exactly 1:1

Make sure you have Autocenter on and everything shoud be OK

Oh, I forgot to mention have your border set at 0

Anthony
 
Status
Not open for further replies.

Latest threads

Back
Top