Please HELP: need routine to find centroid of surfaces

Discussion in 'AutoCAD' started by Bradip Pitt, Sep 18, 2003.

  1. Bradip Pitt

    Bradip Pitt Guest

    Hello everybody, I'm a novice user of AUTOCAD and I'm starting learning
    about AUTOLISP and Autocad customization...I'm lookin for an AUTOLISP
    routine which can find the centroid (a.k.a. center of mass) of a selected
    surface and possibly place a
    reference system (UCS), as much as possible (depending on the configuration
    of the
    surface) parallel to the fixed one (UWS), in that point.

    Will apreciate very much every kind of help

    Alberto (preparing his mechanical engineering final thesis)
     
    Bradip Pitt, Sep 18, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.