Pleas HELP: Need a routine to find the centra of surface

Discussion in 'AutoCAD' started by Raniero, Aug 1, 2003.

  1. Raniero

    Raniero Guest

    Hello everybody, I'm a novice user of AUTOCAD and I'm starting learning
    about AUTOLISP and Autocad customization...I'm lookin for an AUTOLISP
    routine which can find the centre of a selected surface and possibly place a
    reference system, as much as possible (depending on the congiuration of the
    surface) parallel to the fixed one, in that point.

    Will apreciate very much every kind of help

    Alberto (preparing his mechanical engineering final thesis)
     
    Raniero, Aug 1, 2003
    #1
    1. Advertisements

  2. Raniero

    Raniero Guest

    Hello everybody, I'm a novice user of AUTOCAD 2000 and I'm starting learning
    about AUTOLISP and Autocad customization...I'm lookin for an AUTOLISP
    routine which can find the centre of a selected surface and possibly place a
    reference system, as much as possible (depending on the congiuration of the
    surface) parallel to the fixed one, in that point.

    Will apreciate very much every kind of help

    Alberto (preparing his mechanical engineering final thesis)
     
    Raniero, Aug 1, 2003
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.