Not Getting "Select Via Layers for Mark Net" form while doing Mark Net

Discussion in 'Cadence' started by RC MURALI, Apr 6, 2011.

  1. RC MURALI

    RC MURALI Guest

    Hi,

    In IC5.10.41, in Mark Net form (obtained through leHiMarkNet command),
    if I select "Select Via Layers" option (against Via Layers used by
    Mark Net), I do not get the form (which is usually a default case)
    which will enable me to highlight desired metal layers.

    How this form can be obtained?

    Thanks & Regards,
    Murali RC
     
    RC MURALI, Apr 6, 2011
    #1
  2. RC MURALI

    Andrew Beckett Guest

    RC MURALI wrote, on 04/06/11 10:01:
    If you change it away from "Select Via Layers" (e.g. to "Default Via Layers"),
    and then back to "Select Via Layers" - does it appear then? Are there any
    messages in the CIW when you do this?

    Which subversion of IC5141 are you using (Help->About in the CIW will tell you
    this)?

    Regards,

    Andrew.
     
    Andrew Beckett, Apr 13, 2011
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Getting more than 1 key while in grread

  2. SOS! SAVE ME! cdsSpice could not extract netlist: ERROR: NODE/NET IS NOT ON KEEP LIST AND NOT IN WSF

  3. Connectivity -> Mark Net option in VLE

  4. (IC5141 VLE and not VXL) Getting shapes highlighted by mark net, orextracting shapes belonging to th

  5. Dim. Extension Gap form Center Mark

  6. minimise vba form while viewing window ?

  7. Show a form while program is running?

  8. Error in form while using dwgthumbnail.ocx

Loading...