Newbie Question - 3D to 2D Conversion

Discussion in 'AutoCAD' started by Jason Morris, May 11, 2009.

  1. Jason Morris

    Jason Morris Guest

    Hello, I'm new to ACAD and would like to know how to convert a 3D
    wireframe model to a 2D drawing. Any help is appreciated.

    Thanks
    Jason
     
    Jason Morris, May 11, 2009
    #1
  2. Jason Morris

    Guest Guest

    You need to check the Solview and Soldraw commands. The 2d drawing is
    created in paper space. You are talking about the 2d views of a solid?

    Bob
     
    Guest, May 11, 2009
    #2
  3. Jason Morris

    Yorx Guest

    I believe Soldview and Soldraw will only work on SOLID models, not SURFACE
    models
     
    Yorx, May 12, 2009
    #3
  4. Jason Morris

    Jason Morris Guest

    I'd like to take a wireframe solid model and make 2d views of it.

    Thanks
    Jason
     
    Jason Morris, May 16, 2009
    #4
  5. Jason Morris

    Matt J. Guest

    I'd like to take a wireframe solid model and make 2d views of it.

    If you're still looking for a solution, check out the flatshot
    command. It should do what you want.

    -Matt
     
    Matt J., Jun 21, 2009
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.