NEED: Single Line Font... (must be single line inside SW also, nptjust MS Word)

Discussion in 'SolidWorks' started by Ronni, Nov 30, 2007.

  1. Ronni

    Ronni Guest

    I have tried quite a few fonts but havent found one I can use yet.

    CAMworks font: Letters are close to eachother, and if I manually space
    them they are too far apart.

    http://www.linotype.com/183979/agilitahairline-font.html
    Tried the above which looks like I could use it, and it is a single
    line font in MS Word... But SW adds thickness to it.

    So basically I need a single line font that can be used for engraving
    numbers and letters into alu/steel plates with a milling head of ø3
    (smaller makes it unreadable with the unit height we are using)
     
    Ronni, Nov 30, 2007
    #1
  2. Ronni

    j Guest

    j, Nov 30, 2007
    #2
  3. Ronni

    Ronni Guest

    Hey J

    thx for posting

    I already tried this font and it is very similar to the CAMworks
    font.
    And its the same problem, the letters are too close to another :-(
     
    Ronni, Dec 3, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.