Need Help

Discussion in 'AutoCAD' started by Daniel Perez, Apr 25, 2021.

  1. Daniel Perez

    Daniel Perez

    Joined:
    Apr 25, 2021
    Messages:
    1
    Likes Received:
    0
    I am a union licensed electrician and generally clueless when it comes to CAD and computers and everything in between. Although I use a tape measure at work, CAD is above my calling. Not even sure if I am in the right department but here goes: Inset branch is cut at 24 inches. The test subject is in the same plane as the branch but it is rotated a bit. Is there a way/method of using that 24 inch branch to measure the person? I was fooling around with it but I am mostly clueless as to whether it can be done with CAD or some sort of application. Daniel in Los Angeles. KM.jpg
     
    Daniel Perez, Apr 25, 2021
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.