Multiple polygon attributes for LVS

Status
Not open for further replies.

Steve Schwarzbek

Usenet Archive
Joined
Mar 19, 2000
Messages
8
Reaction score
0
In Diva, Id like to add parameters other than area and length of a recognition layer - I want the area and length of three or four other layers that are part of the device also, all to be parameters of the same instance in the extracted view. Is there a way to save parameters, and associate separate polygons into one device? Alternatively, can I read out the CDF parameters of an instance and place them on the extracted instance?

Steve Schwarzbek
TRW "EPS"
 
You need to use the measureParasitic rule to do the actual measurement. The attachParasitic rule will handle adding the property to the instance. It will also allow a shape on a third layer to associate the measured shape to the recognition shape.

Be careful when associating the measurements. If there are multiple shapes on a single layer, the measurements will be combined unless you provide multiple property names for them to be stored in.

On 15 Jan 2002 10:37:59 -0800, (Steve Schwarzbek)
wrote:

In Diva, Id like to add parameters other than area and length of a recognition layer - I want the area and length of three or four other layers that are part of the device also, all to be parameters of the same instance in the extracted view. Is there a way to save parameters, and associate separate polygons into one device? Alternatively, can I read out the CDF parameters of an instance and place them on the extracted instance?

Steve Schwarzbek
TRW "EPS"
 
I'm assuming your situation is that you're extracting a device that has multiple regions of interest from a measurement standpoint. If so, your device recognition shape must be such that it contains or touches all the areas to be measured. For example, the typical mos extraction uses the gate as the recognition shape. Multiple parallel mos devices are then permuted by the lvs rules. In the case of precharacterized RF mos devices, you could instead use the active or diffusion as the recognition shape and then use the measureParameter to count the number of gates contained. You could use additional measureParameter calls to measure additional shape features relative to the recognition shape. Remember that the primary layer in measureParameter must be a recognition shape or derived from a recognition shape.

If all else fails, you can post process the extracted database with skill code at the end of the divaEXT.rul file.

steve

"Steve Schwarzbek" wrote:

In Diva, Id like to add parameters other than area and length of a recognition layer - I want the area and length of three or four other layers that are part of the device also, all to be parameters of the same instance in the extracted view. Is there a way to save parameters, and associate separate polygons into one device? Alternatively, can I read out the CDF parameters of an instance and place them on the extracted instance?

Steve Schwarzbek
TRW "EPS"
 
Status
Not open for further replies.

Latest threads

Back
Top