Multiple configs in BOM for parts on a drawing

Discussion in 'SolidWorks' started by Wayne Tiffany, Dec 7, 2005.

  1. With the new SW BOM you can have more than one config referenced and
    therefore show the common and non-common parts in an orderly fashion. But
    it only works with an assy.

    We had an application here where the guy wanted to show a family of a part
    that had 5 configs, each differing in length, in one SW BOM. He also had 3
    part families that he was showing on this drawing. To accomplish his desire
    to group each family in its own BOM, we created a dummy assy with one each
    of the 5 config parts, and then used that as the basis for the BOM. Worked
    pretty well, and gave him the drawing look he desired.

    WT
     
    Wayne Tiffany, Dec 7, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.