Multiline text flipping in print mode - AutoCad Map 3D - 2014

Discussion in 'AutoCAD' started by Susan Russell, Nov 14, 2017.

  1. Susan Russell

    Susan Russell

    Joined:
    Nov 14, 2017
    Messages:
    1
    Likes Received:
    0
    I am using paper and model space. My design for a water line project is done in model space and I put the sheet border, title block and construction notes in paper space. I have a raster the I clipped and put in model space for my aerial. The flyovers that my company uses are not up to date. In paper space I also have a vicinity map that was clipped an xref'd into the drawing. The annotation is multiline. All is good until I get ready to print, then on print or in print preview the text are flipped 90 degrees. This has happened in two separate drawing files. Has anyone else experienced this?
    upload_2017-11-14_8-25-49.png
    upload_2017-11-14_8-26-29.png
     
    Susan Russell, Nov 14, 2017
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.