Model of Jaws & Teeth?

Discussion in 'SolidWorks' started by Bo, May 19, 2005.

  1. Bo

    Bo Guest

    Does anyone know of an accurate set of jaws with teeth available in a
    format importable into SolidWorks?

    Many Thanks - Bo
    Bo, May 19, 2005
  2. i have a skull from a project its only an stl from a 3d scan though
    mike.mcdermid, May 19, 2005
  3. Bo

    Bo Guest

    Does this mean skull with lower jaw including the teeth?

    Thanks - Bo
    Bo, May 19, 2005

  4. my fault yes a skull with jaw and top and bottom teethe i suppose you
    could cut off the offending cranium
    mike.mcdermid, May 19, 2005
  5. Bo

    Bo Guest

    Hmmm. Sounds like it could do the trick.

    I don't know the file size, but STL sounds HUGE, and not likely to get
    through email.

    Is it possible to pick up via FTP?

    Thanks - Bo
    Bo, May 19, 2005
  6. checked the model and it has a seperate jaw file size is 478kb

    drop me a mail with your e mail and ill send it alternately i do have a
    site you could download it from but it will be tommorrow before i can
    get it up(onto the site i mean)
    mike.mcdermid, May 19, 2005
  7. Bo

    Montie Guest


    If possible, I would like to have a copy of the skull and jaw too.
    I'll be happy to host the file on my website, if you want to allow
    others download it.

    Montie Design
    Montie, May 20, 2005
  8. Bo

    Bo Guest

    Mike is working over the faceting size, and the scaling (4 meters wide
    at the mandibular joint).

    More info later.

    Bo, May 20, 2005
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.