MDL setelmz (flatten)

Status
Not open for further replies.

charles

Usenet Archive
Joined
Jun 2, 2001
Messages
9
Reaction score
0
I have used the subject MDL for some years with much success for flattening out 3d files to a single plane in a 3d dgn file. However, I have also found, to my dismay, that many times if I use it twice or more many enitities disappear. Such as terminators in dimensions, cells etc. They're gone and unrecoverable.

Anyone else experience the same. Is there a solution other than do not use more than once on same file? I make it a point to save a backup of the file before performing this command.
 
I have not used the aforementioned MDL before. When we wish to flatten items we isolate those items through turning levels on/off and using a fence. We set our active depth to the target plane. Then, we scale the selected items with X=1.0000, Y=1.0000, Z=0.000001 This flattens the items to the active depth and we have never had elements disappear in the process.

HTH,

James

"charles" wrote:

I have used the subject MDL for some years with much success for flattening out 3d files to a single plane in a 3d dgn file. However, I have also found, to my dismay, that many times if I use it twice or more many enitities disappear. Such as terminators in dimensions, cells etc. They're gone and unrecoverable.

Anyone else experience the same. Is there a solution other than do not use more than once on same file? I make it a point to save a backup of the file before performing this command.
 
Status
Not open for further replies.

Latest threads

Back
Top