Mating to planes

Discussion in 'SolidWorks' started by Pete Newbie, Jun 8, 2004.

  1. Pete Newbie

    Pete Newbie Guest

    Just a little note for the peeps who do not know this yet!

    If you plane to mirror an assembly, do NOT use planes for mating, the mates
    will NOT carry over into the mirrored Part.

    I found this out, after my work partner had made an assembly, using this
    method.
    I wanted to change a distance mate, (this was between a plane and a
    surface), this worked on the original part, but the mirrored part stay the
    same!!

    Every little helps! :)
     
    Pete Newbie, Jun 8, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.