Looking for the best CAM software for punching

Discussion in 'SolidWorks' started by cad3deng, May 5, 2006.

  1. cad3deng

    cad3deng Guest

    I'm looking to replace our present software, "Merrymech", that we're
    using for
    programming our punch presses, with something that works well with
    SolidWorks.
     
    cad3deng, May 5, 2006
    #1
  2. cad3deng

    CS Guest

    fabriWin is somewhat integrated into SolidWorks. It will flatten your
    part and convert it for you. It is a one at a time thing and doesn't
    have open API to automate going through an assembly. I didn't use it
    too much for a punch myself because we had replaced our punch with a
    plasma and pretty much abandoned the punch except for a few aluminum
    parts and some of the thicker gages that needed tighter hole
    tolerances. For plasma it was extremely easy to program though.
     
    CS, May 15, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Punching Output Noise in phase noise simulations

  2. What is the best GIS software??

  3. CAM works vs Master CAM

  4. new best servise for engineer (cad/cam)

  5. anybody using cam software imbedded in solidworks?

  6. Need programms for engineers (CAD/CAM) BEST DISCOUT

  7. What's the best program CAD-CAM ?

  8. Looking for KIP Toner, scanner controller card and software

Loading...