Looking for Rows in tables - AS7

Discussion in 'AutoSketch' started by rsdav1, Aug 23, 2003.

  1. rsdav1

    rsdav1 Guest

    Using AS7 under Win XP with 256M RAM. I can open a .DWG (AutoCAD 2k) file, modify and save it as .SKF without problems, but when I go to open it again, the system says "Can't find Row 53 in table 9", apparently for each object in the drawing. After acknowledging each message (which can be exciting!), it just gives up and crashes. I can re-open the original drawing each time, but the SKF file is unreadable - until it decides to load only a small part. Any ideas?
    rsdav1, Aug 23, 2003
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.