Looking for plotter info

Status
Not open for further replies.

Dick Osborne

Usenet Archive
Joined
Aug 25, 2000
Messages
4
Reaction score
0
I do civil engineering out of my house using MicroStation V8. I am thinking of an HP 1050c plotter. Wondering if anyone has any experience with it, good, bad or otherwise. Is it fast, easy to network, no driver problems, etc. Anyone have any other suggestions?

Thanks
 
We are looking to upgrade to a similar unit and am interested in other opinions. Also, how does the HP 800PS compare? It is less expensive and seems to have similar capabilities and higher resolution.

John

"Dick Osborne" wrote:

I do civil engineering out of my house using MicroStation V8. I am thinking of an HP 1050c plotter. Wondering if anyone has any experience with it, good, bad or otherwise. Is it fast, easy to network, no driver problems, etc. Anyone have any other suggestions?

Thanks
 
Both are easy to network, but the HP 1050c is both faster and more reliable with HP-GL/2. Also the firmware of the HP 800 (PS) was shaky to say the least. We had al kinds of problems like "system crashes" when pressing the cancel button. The HP-RTL support is also terrible on the HP 800. Very slow and unreliable. We reverse engineered the PCL3GUI format to give our customers a better printing solution. The PostScript 3 support of the HP 800 is good. Also since the HP 800 can do 1200x1200 dpi you can have very crisp output if you have the patient. If you want to do production plotting, better use the HP 1050c.

Theo
"John Cannon" schreef in bericht

We are looking to upgrade to a similar unit and am interested in other opinions. Also, how does the HP 800PS compare? It is less expensive and seems to have similar capabilities and higher resolution.

John

"Dick Osborne" wrote:

> I do civil engineering out of my house using MicroStation V8. I am
> thinking of an HP 1050c plotter. Wondering if anyone has any experience
> with it, good, bad or otherwise. Is it fast, easy to network, no driver
> problems, etc. Anyone have any other suggestions?
...
 
Dick Osborne wrote:

I do civil engineering out of my house using MicroStation V8. I am thinking of an HP 1050c plotter. Wondering if anyone has any experience with it, good, bad or otherwise. Is it fast, easy to network, no driver problems, etc. Anyone have any other suggestions?

Thanks
We have several 1050C's. They seem quite fast and robust. We use Iplot and MicroStation print/plot to drive them. With 128 Mb of RAM added (optional) they can handle some pretty large aerial photos with print/plot. We use the JetDirect cards to connect them to the network (optional) they are easy to set up with NT networking. They probably work well with other NOS's as well but we haven't tried that.

The large reservoir ink systems also are nice, but when it comes time for more ink it is spendy. I suppose though, cheaper than those older plotters with smaller cartridges.
 
We had to replace our Hp755cm and had the change to test a 1055 in an other department. We couldn't plot a large image and used a blue cartridge in a few days. We decided to buy a hp5000ps. It is faster, has a 20GB disk and in the long run we will save the difference in price because it is cheaper in ink. Bob "Dick Osborne" schreef in bericht

I do civil engineering out of my house using MicroStation V8. I am thinking of an HP 1050c plotter. Wondering if anyone has any experience with it, good, bad or otherwise. Is it fast, easy to network, no driver problems, etc. Anyone have any other suggestions?

Thanks
 
Status
Not open for further replies.

Latest threads

Back
Top