Looking for a solidworks help.

Discussion in 'SolidWorks' started by prometheus_au, Feb 22, 2006.

  1. G'day all...

    I'm working on a modelling project which requires some rapid
    prototyping to be done. I've attempted to use 3dsMax but I've little
    (almost no) CAD experience at all.

    What I'm looking at having done is basically a three sided box with the
    sides made up of compound curves on the outside, square cavities inside
    and doors & windows along the side. The dimensions of which are
    35.04mm (w) x 264.36mm (l) x 33mm (h)

    I've attempted to use MeshCAM to convert a black & white cross section
    of what is required into an STL file, but the local rapid prototyping
    service advised me the file couldn't be read.

    Is there anyone out there who would be willing to take this on? It's
    probaly a small job that shouldn't take an experinced person more than
    a couple of hours but I am willing to pay for your time of course.

    Regards
    Dave.
     
    prometheus_au, Feb 22, 2006
    #1
  2. prometheus_au

    Fye Guest

    Tried to send you an e-mail Dave, but it bounced-back to me. I may be
    able to help with your project if you could send a little more
    information about what you want modeled up.

    Shoot me an e-mail.
     
    Fye, Feb 23, 2006
    #2
  3. prometheus_au

    Ben Eadie Guest

    Ben Eadie, Feb 23, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.