Item numbers don't match bill material!

Discussion in 'SolidWorks' started by Peter Cram, Mar 29, 2005.

  1. Peter Cram

    Peter Cram Guest

    Has anyone seen this problem, 2004 sp5 the item numbers that a put on the
    drawing don't match the items numbers in the solidworks bom? If so is there
    a fix?
     
    Peter Cram, Mar 29, 2005
    #1
  2. Peter Cram

    CS Guest

    Item numbers don't show properly through Broken-Out sections I have reported
    this but haven't heard that is has been fixed. To work around you have to
    attach to edges only and not surfaces in broken-out sections.

    Corey
     
    CS, Mar 29, 2005
    #2
  3. Peter Cram

    John Layne Guest

    Same applies to interfering bodies, i.e. if you have a PEM Fastener in
    the assembly. This may be fixed in SWX2005 SP2 have yet to try it.

    John Layne
     
    John Layne, Mar 29, 2005
    #3
  4. Peter Cram

    Richard Charney Guest

    You could try doing this, select a view that you already ballooned. Then RMB
    and go to 'Properties...' for that view. In the lower left corner, check the
    box to 'Keep linked to BOM' and make sure you select the correct BOM from
    the drop down list. Usually 'Bill Of Materials1'. This always fixes that
    problem for me.

    Richard
     
    Richard Charney, Mar 30, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. why the two curve didn't match each other and how to get them match

  2. DASH NUMBERS IN THE BILL OF MATERIALS

  3. Bill of Material and Family table of Assembly

  4. Balloon numbers do not match BOM

  5. SW2007 Bill Of Material Issue

  6. bill of material problem

Loading...