Hole Wizard flips direction on curved surface

Discussion in 'SolidWorks' started by Chebeba, Jul 10, 2006.

  1. Chebeba

    Chebeba Guest

    I am using (in 2006SP4.1) a Hole Wizard to create 6 CSK M5 holes on a slightly
    bent plate (Slightly means less than 5 degrees bend across the length of the
    plate). The points that define the hole locations are constrained on the same surface.

    4 out of 6 holes come out OK, but two holes are flipped, the hole cut extends out
    from the surface of the plate into thin air, rather than into to plate.

    I can't figure how to flip these???
     
    Chebeba, Jul 10, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Engraving on a Curved Surface

  2. Pattern a extruded surface around a multi curved surface

  3. disable certain hole wizard tapped hole sizes?

  4. counterbore wizard on curved surface?

  5. Sheet metal flips part

  6. fasten two parts with curved surface

  7. How to make a circular and rectangular cut on a curved surface in SW

  8. Want to add your own hole geometry to Hole Wizard?

Loading...