Help: Seeing Problems With Build M120 Of WildFire 2.0

[Andy]

Hi Gang

First off is there a more reliable build than M120 for Wildfire 2?

We just installed this build on recommendations from other users at the
PTC conference (in June) However we're seeing the following problems.

1. Multi-sheet drawings do not show as separate sheets they are shown
as 1 sheet with both drawings superimposed on that sheet.

2. We are using Intralink 3.3 and we can't view any thumbnails of older
models (made in Wildfire 1).

Please help.
Andy

 

[John Wade]

Hi Andy:
You can also look forward to:
Layers not working properly
An order of magnitude more crashes
A reduction in throughput of about 20%

I recommend, if you aren't too deep into it, you throw it out. We are
trialling it here, and are recommending rejection.

 

[Andy]

Thanks for the comments John.

Apparently there is no fix to our problem other than re-checking the
drawing back into ProIntralink using W/F 2. This gives you a proper
multipage thumbnail.

Andy