Hello from spain, trouble

Discussion in 'AutoCAD' started by Albertin, Nov 3, 2005.

  1. Albertin

    Albertin Guest

    I have the 2005 version and I want to make an arm of a fan.... I've tried to
    extrude a square along a curve but, the obtained object is not what I want.
    Any way to do or website where it is explained??

    Many thanks from spain
    Albertin, Nov 3, 2005
    1. Advertisements

  2. Albertin

    Robert Guest

    Draw both two end circles separated by the total lenght neededd from end
    point to end point then one straight lines from quadrant to quadrant then
    use trim easylike as it sound to achieve the end result.

    gish regards

    Robert, Nov 4, 2005
    1. Advertisements

  3. Albertin

    Robert Guest

    Robert, Nov 4, 2005
  4. Albertin

    Robert Guest

    Why fly to Australia to go the next corner in Madrid when you already in

    Omg where did you learn the basics

    Robert, Nov 4, 2005
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.