Get File Error (BWCCENC.DLL) on program startup - Black lines print in faint gray colour

Discussion in 'AutoSketch' started by sketch2user, Feb 10, 2004.

  1. sketch2user

    sketch2user Guest

    Since installing my AutoSketch 2 program onto a computer with XP Home
    Edition I have the following problems:

    (1) On loading the program I get the File Error (Cannot Find BWCCENC.DLL) -
    by just closing the dialogue box the program then loads normally.

    (2) The black lines appears a faint grey on the computer screen and also
    print out in an extremely faint grey. I can use any of the other colours and
    they appear and print quite normally.

    Your help to either or both of these problems will be much appreciated.
     
    sketch2user, Feb 10, 2004
    #1
  2. sketch2user

    Len Rafuse Guest

    I can't help thinking that your lucky it runs at all since AS 2 is quite
    old.

    Have you looked at the Compatibility tab for the run properties? There
    are options that may help there such as run in win 95 mode and 256 colors.
     
    Len Rafuse, Feb 11, 2004
    #2
  3. sketch2user

    Micha Guest

    Hi,
    your first problem i can't reproduce.
    2. To plot with AS 2.1in correct colours i have downloaded
    the Tool "FreePDF" and have used a HP-PostScriptPlotter driver in FreePDF to generate a PDF file. This PDF i can print to the normal HP-Plotter (450C). This way is complicated, but it works fine.

    Regards
    Micha
     
    Micha, Feb 13, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.