DWF cutting of top and bottom of 8x11 layouts

Discussion in 'AutoCAD' started by Tobi Yarbrough, Aug 20, 2004.

  1. Tobi Yarbrough

    Tobi Yarbrough Guest

    All other sizes print fine. It seems the printable area is rather small.
    Which .pc3 controls the DWF? Printing or Viewing?
     
    Tobi Yarbrough, Aug 20, 2004
    #1
  2. Tobi Yarbrough

    Tobi Yarbrough Guest

    I'm using the Publish button. The border is about 1" from the paper edge.
    That should be more than enough.
     
    Tobi Yarbrough, Aug 20, 2004
    #2
  3. Tobi Yarbrough

    David Metcalf Guest

    Yes but you could get away with .25 margins no 99% of the printers. Our in
    house laser printer is good with .15 margins. Some inkjets don't print that
    close so .25 is our standard to implement with clients Composer DWF setup.

     
    David Metcalf, Aug 25, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Snap Toggle at bottom of drawing editor 2002

  2. Limit dimensioning - top/bottom or right/left option

  3. Which method is best, Top-Down or Bottom-Up

  4. Models - Top down or Bottom up?

  5. HP 1050c: Adjusting Top/Bottom Margins

  6. Printing Says 11x17 but its printing 8x11

  7. New to Inventor and want to move parts from sub-assy into top level assy and retain the constraints

  8. How to transform top level bBox into an instance bBox(top level tolevel1) ?

Loading...