Drawing line on command line.

Discussion in 'AutoCAD' started by jparkerri, Feb 22, 2004.

  1. jparkerri

    jparkerri Guest

    Could someone tell me how to draw a line on the command line? I thought it
    was the PLINE command with something like "@distance<angle" but it isn't
    working. I'm using AutoCad Map 2.0.

    Thanks.
     
    jparkerri, Feb 22, 2004
    #1
  2. jparkerri

    Dave Byrnes Guest

    You have to start off with either a point picked on screen or absolute
    coordinates entered on the command line. THEN you can use relative
    coordinates with @distance<angle.

    This is the case with both LINE and PLINE commands.
     
    Dave Byrnes, Feb 22, 2004
    #2
  3. jparkerri

    jfranklin Guest

    i believe it's different if the units are different. are you using architectural units?
     
    jfranklin, Feb 24, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Opening a Drawing as READ ONLY from the Command Line?

  2. Command suppression using (command "vplayers"..)

  3. How to run code from clipboard to command line

  4. getkword returns command command at prompt?

  5. aecobjexplode - command line troubles

  6. Command to Undo Last Layer command?

  7. Pause the Running Command ----- other Commands ----- Resume theprevious stoped Command

  8. Light command, only command type interface?

Loading...