Diva (4.4.6) denies permuteDevice(MOS... permuteDevice(seriesN...

Status
Not open for further replies.

MIchael Buchmann

Usenet Archive
Joined
Feb 4, 2000
Messages
9
Reaction score
0
Hi,
We are using opus4.4.6.100.23 and a new problem came up with diva LVS. We have the following in divaLVS.rul:

permuteDevice(MOS "pmos" )
permuteDevice(seriesN "pmos" "D" "S" serielMOS)

Diva aborts execution with the message:
Error: Device "pmos" may not combine seriesN with MOS permutation.

It worked fine in older 4.4.3.100.27 versions. When I remove either MOS or seriesN command it works, but I lose either MOS permutation or series combination. We would like to have both as we always had. I found nothing in the documentation. Any Idea? Thanks in advance.

Michael Buchmann
Nokia Research Center
 
Use the series permutation instead of seriesN and you'll be OK.

On Fri, 07 Dec 2001 08:40:25 GMT, MIchael Buchmann
wrote:

Hi,
We are using opus4.4.6.100.23 and a new problem came up with diva LVS. We have the following in divaLVS.rul:

permuteDevice(MOS "pmos" )
permuteDevice(seriesN "pmos" "D" "S" serielMOS)

Diva aborts execution with the message:
Error: Device "pmos" may not combine seriesN with MOS permutation.

It worked fine in older 4.4.3.100.27 versions. When I remove either MOS or seriesN command it works, but I lose either MOS permutation or ...
 
Edward J Kalenda wrote:
Use the series permutation instead of seriesN and you'll be OK.
This really works. I find it strange because according to the manual seeries is for two terminal devices and seriesN for others where you give the names of the terminals, but as long as it works I do not mind. Thanks very much for the help,

Michael Buchmann
 
Actually, the series permutation is for two or three terminal devices. Two terminal devices are clear in their behavior. Three terminal devices have to have two permutable pins followed by a third non-permutable pin. The section "Permuting Devices" of the Diva Reference Manual discusses this. I expect seriesN was added later to allow more control over series reduction and the manual was not updated as well as it should have been.

On Mon, 10 Dec 2001 08:43:06 GMT, MIchael Buchmann
wrote:

Edward J Kalenda wrote:
>
> Use the series permutation instead of seriesN and you'll be OK. This really works. I find it strange because according to the manual seeries is for two terminal devices and seriesN for others where you give the names of the terminals, but as long as it works I do not mind. Thanks very much for the help,

Michael Buchmann
 
Status
Not open for further replies.

Latest threads

Back
Top